RVLock Charter Motor Installation

RVLock Charter Motor Installation

1. Remove the lock from the door by unscrewing the three screws in the back of the lock and two in the side of the door.

2. Place the lock face down on a clean surface.

3. Remove the four screws from the silver plate.

4. Remove the silver rod and the clutch.

5. Remove the three screws from the motor cover.

6. Remove the motor from the housing and clean off the green adhesive to disconnect the wires. 

7. Repeat the steps in reverse to install the new motor.
   
                    Silver plate screws                                              Silver rod and clutch
   

   

   

                         Motor cover screws                                                  Motor and wires