White Baggage Actuator Installation
Remove the lock from the door.
Remove the front paddle from the lock by taking out the 2 screws located on each side of the lock.
While holding down the remainder of the white baggage actuator with your finger, use a screw driver to remove the screw on the back of it.
Grab the new white baggage actuator.
Insert the new actuator from the front side. While holding it in with your finger, reassemble the part with the screw located on the backside.
Make sure to not over-tighten, as is it pressure sensitive and can strip out.
Note: If the white actuator breaks, this is a sign that the baggage handle was installed too tight. Please adjust the door jamb plate or stop modification towards the outside of the rig! This should relieve some of the pressure off that door latch and keep it running smoothly!