Red Lever Kit

First, you will insert the red lever through the hole in the back portion of the lock so the lever part is on the outside.Then you will place the silver washer over the end of the red lever (it will sit inside a small groove on the inside of that back portion).

You will need to secure the red lever so it doesn't bounce around (because you will need to put a little bit of pressure on it.)

Once it is secured you are going to put on the C clip.

You will put the C clip on top the red lever, then hold down one side.

You will take a small instrument, and while holding down the one side, you will push down around the C clip to lock it into place.