Installation

To install your Atlas Handle please reference the installation video found here .  To install your Atlas Handle you may need the following tools: Phi...

V4 Keyless Handle Installation  Remove Your Existing Handle Latch your RV door in the open position. Remove the 4 screws from the back of your existin...

Compact Keyless Handle Installation  Remove Your Existing Handle Latch your RV door in the open position. Remove the 4 screws from the back of your ex...

Remove Your Existing Handle Latch your RV door in the open position. Remove the screws from the back of your existing handle.  Remove the screws from ...

Remove Your Existing Handle Latch your RV door in the open position. Remove the 4 screws from the back of your existing handle.  Remove the two screws...

Remove Your Existing Handle Latch your RV door in the open position. Remove the 4 screws from the back of your existing handle.  Use a 1/16th" drill b...

Remove Your Existing Handle Latch your RV door in the open position. Remove the 4 screws from the back of your existing handle.  Install Your keyless ...

The standard door thickness is 1 ½". The locks are built for that standard size. We have a spacer available for purchase if your door is between 1 ¼" ...

Remove the lock from the door Place the lock on a flat and clean surface with the numbers facing down  Remove the 4 KPD screws(You may need to remove ...

RVLock Compact Motor Installation Remove the lock from the door by unscrewing the four screws in the back of the lock and two in the side of the door....

RVLock Charter Motor Installation Remove the lock from the door by unscrewing the three screws in the back of the lock and two in the side of the door...

Remove the lock from the door Place the lock on a flat and clean surface with the numbers facing down  Remove the 5 KPD screws(You may need to remove ...

Installing A New PCB On An RVLock V4: Remove the Four Screws in the back portion of the lock. Disconnect the red and white wires Remove the battery co...

Installing A New PCB On An RVLock Charter: Remove the three screws in the back portion of the lock. Disconnect the red and white wires Remove the batt...

Installing A New Pcb On A Compact And Class C/A: Remove the Four Screws in the back portion of the lock. Disconnect the red and white wires Remove the...

To determine which lock you will need, there are a couple of ways to verify compatibility between your rig and RVLock products. You can visit our fit...

Remove the lock from the door. Remove the top and bottom paddle screws  Pull the front paddle straight out. Put the "L" bracket on and then put the se...

The RVLock Key Latch and Thumb Latch fits most standard rig doors.    RVLock Key Latch/Thumb Latch Dimensions: Threaded shaft dimensions are .75" wide...

Remove the lock from the door Place the lock on a flat and clean surface with the numbers facing down  Remove the 5 KPD screws(You may need to remove ...

Remove the lock from the door Place the lock on a flat and clean surface with the numbers facing down  Remove the 4 KPD screws(You may need to remove ...

Remove the lock from the door. Remove the front paddle from the lock by taking out the 2 screws located on each side of the lock. While holding down t...